...
A Software Download login is required to access the software download area. If you do not yet have a login, please contact support@calnexsol.com.
...
R15.1
| Note |
|---|
Please read Sentinel: Clock Channel Triggers Always on Negative Slope before applying this software |
Features
OTA-NR Cell Scan
This release adds cell scan capability for OTA-NR, similar to the existing cell scan feature for OTA-LTE. For full details please refer to the Sentinel User Manual.
...
R15
| Note |
|---|
Please read Sentinel: Clock Channel Triggers Always on Negative Slope before applying this software |
Features
Added Metrics and Masks
A range of metrics and masks have been added to Sentinel as summarised in the table below:
...
[SEN-2514] During a 5G OTA measurement, if the signal loses lock and then regains lock the graph doesn’t update
[SEN-2476] During an OTA measurement, the widget was indicating the opposite sign to the graph
...
R13
| Note |
|---|
Please read Sentinel: Clock Channel Triggers Always on Negative Slope before applying this software |
Features
HTTP(S) Interface
An HTTP(S) interface has now been added to Sentinel allowing a basic remote control functionality. For full details please refer to the Sentinel User Manual.Continuous Measurements
An option has now been added to the measurement settings page to allow the user to select continuous measurements. This means that Sentinel will continue to make a measurement on a rolling 24 hr basis.IPv6 on the Management Port
There is now the ability to use IPv6 addresses on the management port for Sentinel.Disable SyncE
SyncE can now be disabled independently of PTP/NTP measurements. This feature is available via the mode page.Disable Metrics
If you don’t want to run any metrics or masks you can disable this on the measurement settings page.
...