Paragon-X Information
- Kevin Godfrey
- Gordon Muir (Deactivated)
- Billy Marshall
Owned by Kevin Godfrey
Last updated: Sept 23, 2022 by Billy Marshall
- Paragon-X: Minimum PC Requirements
- Paragon-X: How to use the GUI
- Paragon-X: What do the LEDs mean in Master-Slave Emulation mode?
- Paragon-X: Why is calibration needed for Jitter but not for Wander?
- Paragon-X: IPv6 Address Format
- Paragon-X: How is the CCSA ToD FCS Calculated?
- Paragon-X: Can I measure the time error of a DUT when switching between masters?
- Paragon-X: How is jitter calibration performed?
- Paragon-X: Why can't I change my 1PPS Reference Input?
- Paragon-X: How is SyncE Wander Transfer Performed?
- Paragon-X: Can Paragon-X be used to measure Enhanced SyncE?
- Paragon-X: What Time of Day formats are supported, and what is their structure?
- Paragon-X/Paragon-neo: In BC Test Mode, why do I see very high T1 and T4 time error when connected back-to-back?
- Paragon-X: Why do I need to set Impairment Flow Filters when performing an impairment in Master/Slave Emulation
- Paragon-X: Why do I need to set the Capture Flow Filters when performing a PTP measurement in Master/Slave Emulation
- Paragon-X: config files (.cst) and compatibility across versions
- Paragon-X: Why do I see Sequence ID errors for Peer Delay Response Follow Up, Announce and Signalling Messages?
- Paragon-X: are 10G RJ45 links supported?
- Paragon-X: Support for 100BaseT1 and 1000BaseT1 transceivers
, multiple selections available,